Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
thinkgear_communications_protocol [2014/06/26 15:01] Amine Bouchti [RAW Wave Value (16-bit)] |
thinkgear_communications_protocol [2017/01/17 16:19] masasomeha [8BIT_RAW Wave Value] |
||
---|---|---|---|
Line 143: | Line 143: | ||
128 times a second, or approximately once every 7.8 ms. | 128 times a second, or approximately once every 7.8 ms. | ||
- | This Data Value is only available in ThinkGear modules. It is not | + | This Data Value is only available in ThinkGear Embedded modules (TGEM). It is not |
- | available from ThinkGear ASIC (such as MindWave and MindWave Mobile). | + | available from ThinkGear ASIC (TGAT/TGAM1), which is used in MindWave and MindWave Mobile. |
===== RAW_MARKER Section Start ===== | ===== RAW_MARKER Section Start ===== | ||
Line 257: | Line 257: | ||
===== Eye Blink Strength ===== | ===== Eye Blink Strength ===== | ||
<note> | <note> | ||
- | This data value is currently unavailable via the TGCD and TGC APIs. It is not directly available as output from any current ThinkGear hardware. For TGCD, see the ''TG_DATA_BLINK_STRENGTH'' data type for use with the ''TG_GetValueStatus()'' and ''TG_GetValue()'' functions. | + | This data value is currently unavailable via the ThinkGear Serial Stream APIs. It is not directly available as output from any current ThinkGear hardware. For TGCD, see the ''TG_DATA_BLINK_STRENGTH'' data type for use with the ''TG_GetValueStatus()'' and ''TG_GetValue()'' functions. |
</note> | </note> | ||
- | |||
- | This unsigned one byte value reports the intensity of the user's most recent eye blink. Its value ranges from 1 to 255 and it is reported whenever an eye blink is detected. The value indicates the relative intensity of the blink, and has no units. | ||