Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
mindwave_mobile_and_arduino [2014/05/13 11:33] Amine Bouchti [Required Materials] |
mindwave_mobile_and_arduino [2014/05/13 11:39] Amine Bouchti [System Overview] |
||
---|---|---|---|
Line 13: | Line 13: | ||
* Arduino Diecimila was used to develop **(please see the note below if you are using a Mega 2560 or Uno)** | * Arduino Diecimila was used to develop **(please see the note below if you are using a Mega 2560 or Uno)** | ||
* BlueSMiRF Silver/Gold, https://www.sparkfun.com/products/10269 | * BlueSMiRF Silver/Gold, https://www.sparkfun.com/products/10269 | ||
- | * Terminal software, such as [[|https://learn.sparkfun.com/tutorials/terminal-basics/coolterm-windows-mac-linux|CoolTerm]], RealTerm, or Terminal | + | * Terminal software, such as [[https://learn.sparkfun.com/tutorials/terminal-basics/coolterm-windows-mac-linux|CoolTerm]], [[https://learn.sparkfun.com/tutorials/terminal-basics/real-term-windows|RealTerm]], or Terminal |
* Arduino development environment | * Arduino development environment | ||
* Avago HDSP-4832 10-Element LED bar graph array | * Avago HDSP-4832 10-Element LED bar graph array | ||
Line 26: | Line 26: | ||
The basic setup flow is as follows: | The basic setup flow is as follows: | ||
- Pair the MindWave Mobile to your computer to determine the MAC address | - Pair the MindWave Mobile to your computer to determine the MAC address | ||
- | - Connecting the BlueSMiRF to your Arduino board | + | - Connecting the [[https://www.sparkfun.com/products/12577|BlueSMiRF]] to your Arduino board |
- Pair the BlueSMiRF to your computer to configure the device | - Pair the BlueSMiRF to your computer to configure the device | ||
- Connect the LED array to the Arduino board. | - Connect the LED array to the Arduino board. | ||
- Download the provided example code into the Arduino board using the Arduino development environment. | - Download the provided example code into the Arduino board using the Arduino development environment. | ||
- Power up the whole system and observe the Attention eSense value on the LED array. | - Power up the whole system and observe the Attention eSense value on the LED array. | ||
- | |||
====== Detailed Instructions ====== | ====== Detailed Instructions ====== | ||